BKI GO-36 Wartungshandbuch PDF herunterladen (Seite 68)

68 / 80



BKI 09 ATEX 0003X



htk4014a0600p_01.doc

The level signal can be optimized by way of two factors:

Amplification factor

The amplitude of the signals is proportional to the dielectric constant 

of the product. At low amplitudes the signal should be amplified.

The amplification factor is dependent on the dielectric constant 

and on the probe type. The device sets the gain automatically.

Gain Amplification factor

0 1.05

1 2.10

2 4.37

The following factors apply to the set gain:

3 8.93

Level threshold

The level threshold suppresses interference signals so that only the reflections from the product surface (level signal) are shown. The factory setting of the level

threshold is suitable for standard applications.

The threshold will need to be adjusted in the case of very low dielectric constants 

multiple interference reflections or unfavourable installation conditions.

The illustrations below show interference signals when the oscilloscope function is used.

These reflections can be due to various causes, e.g. tank internals or multiple reflections within the measuring range.

Even though the interference signals are very weak, the threshold should nevertheless

be set to a value above these signals.

1 Initial pulse

2 Flange reflection

3 Level signal

4 Interference signal

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

BKI GO-36 Wartungshandbuch Seite 68

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen BKI GO-36